Archinect
anchor

printer info

0
bigness

I have the chance of grabbing a bit o f a bargain plotter, an a0 hp designjet 750c plus, the maximum definition in colous is stated at 300 dpi x 300 dpi (does that mean 900 dpi?), which i find kinda low, does anyone know much about it? has anyone used the same plotter?
i would buy it for end of year show/portfolio, then probably sell it off again, i was just wandering if the definition would be enough to print renderings at, or would the come up grainy...so far i've been using an epson 1290 a3 with a max resolution of 2880 dpi...help!

i've got 3 hours to close the deal...


thanks folks!

 
Mar 22, 06 12:37 pm

Block this user


Are you sure you want to block this user and hide all related comments throughout the site?

Archinect


This is your first comment on Archinect. Your comment will be visible once approved.

  • ×Search in: