a very important part of any decent laser cutter is the vacuum, which must be strong enought to hold the material down flat even after the cuts have been made. If you don't have this, many types of material will bow, raising off the bed and away from the focal length of the laser, meaning you will not be cutting all the way through the material.
May 27, 04 5:13 pm ·
·
Block this user
Are you sure you want to block this user and hide all related comments throughout the site?
Archinect
This is your first comment on Archinect. Your comment will be visible once approved.
1 Comment
a very important part of any decent laser cutter is the vacuum, which must be strong enought to hold the material down flat even after the cuts have been made. If you don't have this, many types of material will bow, raising off the bed and away from the focal length of the laser, meaning you will not be cutting all the way through the material.
Block this user
Are you sure you want to block this user and hide all related comments throughout the site?
Archinect
This is your first comment on Archinect. Your comment will be visible once approved.