I have consciously avoided getting one of these as it does not complement my disposition as far as time and $$$ being an architect- employee . but somehow, i have been pulled into almost buying one of them suckers thinking of the gratification this would bring especially when tinkering with grasshopper. what's your stand on this?
m3d (3d micro) vs makerbot replicator mini
I have consciously avoided getting one of these as it does not complement my disposition as far as time and $$$ being an architect- employee . but somehow, i have been pulled into almost buying one of them suckers thinking of the gratification this would bring especially when tinkering with grasshopper. what's your stand on this?
Mechmate... no substitute
Check that... if you cant afford the time or cost... than http://www.grunblau.com/PlatformCNC.htm
Block this user
Are you sure you want to block this user and hide all related comments throughout the site?
Archinect
This is your first comment on Archinect. Your comment will be visible once approved.