so i have a few curves i want to render, i click on "render wireframe", hit render and they don't render, when i go back to chack the settings, the box is now unchecked. i check it again, try again and same thing. anyone know why i can't get the wireframe to render?
Yeah, I don't remember any workarounds other than updating. You might try getting the Flamingo 2 public Beta, the last time I used it it was pretty stable and comparatively speedy.
rendering curves in RHINO
so i have a few curves i want to render, i click on "render wireframe", hit render and they don't render, when i go back to chack the settings, the box is now unchecked. i check it again, try again and same thing. anyone know why i can't get the wireframe to render?
much thanks
sounds like you have an older version of Rhino or Flamingo. As i recall I think they fixed this in a service update.
you are right about that...however it has been working just fine for me...then all of a sudden...poop
Yeah, I don't remember any workarounds other than updating. You might try getting the Flamingo 2 public Beta, the last time I used it it was pretty stable and comparatively speedy.
thanks
Block this user
Are you sure you want to block this user and hide all related comments throughout the site?
Archinect
This is your first comment on Archinect. Your comment will be visible once approved.