What if there was a Standard Detail Uniform Library for details...
Would it expedite Production or Would it eliminate jobs?
We all use a basic detail and modify it to meet our new design or special conditions - New details will always be needed, but what about the typical detail that is basically used by 99% of us when dealing with standard contruction elements such as Partition Type, Door Head/Jamb, Soffits, etc.
Standard Uniform Drawings - good or bad?
What if there was a Standard Detail Uniform Library for details...
Would it expedite Production or Would it eliminate jobs?
We all use a basic detail and modify it to meet our new design or special conditions - New details will always be needed, but what about the typical detail that is basically used by 99% of us when dealing with standard contruction elements such as Partition Type, Door Head/Jamb, Soffits, etc.
http://www.cadopolis.com/prodcaddetails.asp
Block this user
Are you sure you want to block this user and hide all related comments throughout the site?
Archinect
This is your first comment on Archinect. Your comment will be visible once approved.