well there has been some discussion about what to do with 2d drawings extracted from rhino. When sending them to acad what settings do you use? If it has some curves, if you send it with curves as splines, you can't trim extend the curves, so how do you do it?
exporting rhino to ACAD
well there has been some discussion about what to do with 2d drawings extracted from rhino. When sending them to acad what settings do you use? If it has some curves, if you send it with curves as splines, you can't trim extend the curves, so how do you do it?
This is a very unpopular thread.
Block this user
Are you sure you want to block this user and hide all related comments throughout the site?
Archinect
This is your first comment on Archinect. Your comment will be visible once approved.