Archinect
anchor

3D printing advise

what scale? what kind of printer?

ive printed a 6 story 600m2 model at 1:100 with PLA floor by floor. Looks great because its a good scale. no issue with doing it floor by floor. It takes a minute to stack up and align and glue together, but thats pretty easy as model making goes historically speaking. 

printed a 5 story 18000m2 project at 1:500 using a sinter printer. stunning outcome but it was pretty delicate at that scale. It was printed all at once. Since then I am inclined to set PLA printers aside entirely because the sinter print has very fine resolution and can deal with columns in space, etc without any problem. 

ymmv

Oct 2, 24 2:54 pm  · 
 · 

Block this user


Are you sure you want to block this user and hide all related comments throughout the site?

Archinect


This is your first comment on Archinect. Your comment will be visible once approved.

  • ×Search in: