Southern California Institute of Architecture (SCI-Arc)
Pratt Institute
University of Southern California (USC)
Tulane University
University of California, Los Angeles (UCLA)
Temple University
University of Oregon
Cranbrook Academy of Art
New York Institute of Technology (NYIT)
Kansas State University
Soldering wire models
I am having the worst time soldering wire models. I stayed up all night trying to solder a piece of a model for hours only to fail. My solder iron looks toast I've gone thru like a ton of solder and I have till tomorrow to finish one more model. How can I get the solder off the iron and on the two pieces of music wire the solder just stays on the iron till I touch my cutting mat and just gets wiped away hour after hour after hour until I get lucky and get a good drip.to stay.
music wire? probably too thin to hold the weight of the droplet. needs more contact area. in other words, the bond with the iron is stronger. try to bend the wire at the point you wish to solder.
https://www.youtube.com/watch?v=xrVCkEoY_8M
Metal rods one 1mm model and one 1/2 mm model designed from are wandering line drawings not electronics chigurh but it did give some advice on what not to do with electronic wire.
Jila-x could I get away with bent wire with a piece of solder put onto it I think my professor would notice. I'll give it a try I have like less then 24 hrs to get this done two other drawing and math homework before the sun comes up.
Pro tips- use thinner music wire. Use a propane torch w a tiny tip. And flux. Does not work without flux
Block this user
Are you sure you want to block this user and hide all related comments throughout the site?
Archinect
This is your first comment on Archinect. Your comment will be visible once approved.