Archinect
anchor

Brick wall: I need to pin or tape up

citizen

Long story short:  How might you enable pinning or taping up small drawings/ sketches/ photos on a brick wall?  The arrangement needs to be quick, temporary, and removable afterward.

My first thought is to run a horizontal strip of Gorilla Tape to the brick at ~eye level, then tape sheet-tops to the exposed, non-stick tape face.  

Other ideas?

Thanks in advance...

 
Jan 4, 17 7:54 pm
Non Sequitur
Put sturdy double sided tape under two strips of black foam board and pin your drawing on all 4 corners to the foam. If you make the strips long enough, your drawings will all hang at a common height.
Jan 4, 17 8:09 pm  · 
 · 
curtkram

tapcon?

Jan 4, 17 8:09 pm  · 
 · 
batman

drills.

Jan 4, 17 9:08 pm  · 
 · 
Non Sequitur

If you were an interior designer, I'd recommend you just move the wall. No biggie right? It's just a few lines on a page.

Jan 4, 17 9:17 pm  · 
 · 
Janosh

Gaffers tape. Strong enough and leaves no residue.

Jan 4, 17 10:33 pm  · 
 · 

Block this user


Are you sure you want to block this user and hide all related comments throughout the site?

Archinect


This is your first comment on Archinect. Your comment will be visible once approved.

  • ×Search in: